'WigWag' or 'Flasher' Units

One of the most important functions of Landing Lights is to improve your plane's visibility to other aircraft. Flashing the aircraft's lights by using a "wig-wag" circuit contributes significantly to "be-seen" visibility, especially when approaching and operating near an airport. There are several types of devices that can be added to accomplish this...

Duckworks Solid State Flasher II
Duckworks Solid State Simple Flasher

Duckworks Solid State WigWag Flasher II

NOTE - The Flasher II is a new design utilizing uprated, more robust components. Not that there were any issues with the previous unit - except supply - but since we were updating the design, we upped the power capacity as well.

This Flasher is great for new installations, or as a replacement for a setup where you want to upgrade to support HID, or your Flasher has failed or is inadequate and you want to use the switch locations you already have in the panel.

No 'Clacking' Relays - ALL Solid State - Silent operation
Functions in 14 AND 28vdc installations (2 versions - 14v unit NOT 28v compatible)
Compatible with Halogen, LED, and HID Units
Small and lightweight (4.74"L x 1.43"w x 1.18"h, 5.5oz including pigtail)
Alternating Flash at 1Hz Flash Rate
Capable of handling up to 300W (150W per side)
Mixing of HID, LED, and Halogen Lamps OK
Simple connection (Comes with 12" MIL-W-76B 6-wire pigtail)
Uses a Single Pole Double Throw (SPDT) switch (other switch configs possible too)
Easy Mounting with built-in Flange
Full instructions including wiring diagrams

More Information - Instructions and Wiring Diagrams

Note - This unit does NOT have an automatic HID 'warm-up' feature. Pilot must remember to warm-up the HID lights at least 30 seconds before switching to Flash.

Application

Order direct from Duckworks

Price

Order

WigWag for Halogen, LED and HID Lights

DW-WW-II

$90

Top

Duckworks Solid State Simple Flasher

The Simple Flasher is a specific design for use with our 3-LED Lights that have the 3rd wire.

This Flasher can also be used with our Wingtip round LED lights, but only in a very specific installation.

Because of it's very low capacity, it should not be used with Halogen, HID, or high power LED lights.

Small (2"L x .6"w x .2"h, .5oz including pigtail)
Alternating Flash at 1Hz Flash Rate
Capable of handling up to 4W per side
Simple but very specific connection (Comes with 12" Tefzel 4-wire pigtail)
Uses a Single Pole Single Throw (SPST) switch (Separate from the power switch for the LED Lights)
Easy Mounting with built-in Flange
Full instructions including wiring diagrams